Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Set the corresponding thickness of a coin
Put a coin in the feed hopper and start the counter pressing "START" button.
If after several seconds of engine running the coin is ejected from non-counted coins
tube (on the right) move the diameter setting handle 1 division (1 click) back
If after several seconds of engine running the coin is "dangling" in the centrifugal disk
shift the diameter setting handle 1 division (1 click) forward and shift the thickness set-
ting handle in the increase direction.
Make sure that that the coin or a counter should get in the eject stacker of the counted
coins and the display shows the result .
Calibration procedure is required in case of coins and counters of other nominal values
are issued.
Put the results of calibration in a table.
If diameter setting handle is blocked (see p.8), increase the diameter by one or several
divisions (one click=0.33 mm(1/8")).
Face value
Diameter
Thickness
Face value
Diameter
Thickness
17
Werbung
Inhaltsverzeichnis
