Herunterladen Inhalt Inhalt Diese Seite drucken

Safety Precautions; Preparation Before Work - PRO Intellect Technology PRO CS-200A Gebrauchsanweisung

Münzzählmaschine
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

  • DEUTSCH, seite 4
Press M+ to display the final result from the memory, and press and hold simultaneous-
ly any other button for 3 sec. Remember, that current value will be stored when M+ is
pressed, if it is necessary to display the result without current value, then clear this value
by pressing CLR button.
5
1. Read the manual and observe the requirements stated in it before operating the
device.
2. The manual should be available to operator.
3. Do not place the counter in the following places:
on an inclined surface
in humid rooms
in the areas where the equipment is exposed to vibrations
in dusty rooms
where it is exposed to directional sunlight
close to dangerous objects
4. Do not operate the counter with wet hands.
5. avoid getting of liquid or foreign objects into the counter
6. Avoid accidental fall down of the device
7. Before loading the counter make sure that there are no foreign objects. Curved or
damaged coins inside (see p.8)
8. During operation:
- make sure there are no left coins in the stacker hopper and separator (see p.8)
- regularly service and clean the device to keep the set technical parameters
9. Do not disassemble and modernize the counter, it can cause an accident.
6
6.1 Installation of the counter.
Put the counter on worktable
Fix the tray for not counted coins on the right side
Using locking ring fix a sack on the tube for counted coins
Connect network cord to power supply socket
Turn network switch to ON position
6.2 Calibration of the counter.
Attention! Calibration of the counter for Russian coins is not required.
Attention! Calibration of the counter is done once for coins or counters of a certain value.
Additional calibration is required only when new coins or counters with different value
or geometrical sizes (diameter and thickness ) are issued. The rate of one division by
diameter: one click is equal to 0.33mm (1/8")
Attention! Set diameter accurately.
Choose a coin or a counter
Set the corresponding diameter of a coin
16

Safety precautions

Preparation before work

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis