DeFelsko PosiTector RTR H Gebrauchsanweisung Seite 8

NOTE:
It is a good idea to clean the probe regularly with
the included cleaning card. Cleaning is essential prior to
performing a probe Zero (pg. 8) or a verification of accuracy
(pg. 8). Cleaning is best performed when the Gage is
powered off.
After cleaning, power on the PosiTector
the button.
10. Insert the burnished replica tape into
the probe opening as far as it will go.
Ensure the tape is properly positioned
so that the burnished region is
centered within the opening with the
adhesive (sticky) side down.
To position the tape, align the two
dots (printed on replica tape) with
arrows on both sides of the
measurement opening.
During measurement, a constant anvil pressure is applied to
the replica tape regardless of how hard the two buttons are
pressed. The Gage automatically subtracts the 50.8 μm (2
mils) of incompressible polyester film. No further adjustments
are required.
1. Ensure tape is properly positioned.
9. Ensure the correct grade of
replica tape is selected (pg. 3)
and the H
L
displayed at the bottom of the
screen.
NOTE:
If using Coarse Minus
grade replica tape, H
should be disabled. Any grade of
replica tape can be selected from
the Menu.
Align dots with arrows on probe
6
by pressing
icon (pg. 9) is
mode
L