Fuxtec FX-E2MS Bedienungsanleitung Seite 54

Use the automatic feeding
When using as a grass trimmer, this tool is equipped with a bump button for line feeding which
allows the operator to feed the line without stopping the motor.
1. Switch on the brush cutter
2. Lightly tap the button on the surface.
3. The line will be fed out each time the bump button is tapped
NOTICE: When the line is fed out too much, it will be cut by the line cutter to a proper
length.
4. If the thread is not cut correctly, the bobbin may become tangled. In this case, take out the
spool and rewind the line (see winding up new line).
5. If there is too little thread on the spool, you may not be able to feed the thread through the
automatic tapping mechanism. In this case, switch off the device and proceed as in the
following chapter.
Original user manual FUXTEC FX-E2MS_rev01
54