Dog trace d-control Professional Bedienungsanleitung Seite 29

Pairing function keys B1/B2 with the second receiver:
Follow the same procedure as in the previous section, except press function
button B1 or B2 at step 5 of the procedure. If you only want to use the
transmitter to train one dog, all A1/A2/B1/B2 function buttons can be paired to
one receiver. This function can also be used for professional training where you
can pair two different transmitters to one receiver.
Pairing function keys B1/B2 (or the second transmitter) with the first receiver:
1. Turn on your transmitter.
2. Your receiver must be switched on.
3. Place the red target located on the transmitter against the red target on the
receiver for 5 seconds. The green indicator light will illuminate, followed by
the red indicator light.
4. After 5 seconds, both indicator lights will flash 3 times simultaneously. The
green and red indicator lights will then flash alternately.
5. Press button B1 or B2 (or any function button on the other transmitter).
6. Successful pairing is indicated by a long beep from the receiver.
WARNING: If you unpair a receiver from the off state (see Pairing the A1/A2
function buttons with the first receiver), the device that was paired from
the on state will automatically be removed (this is usually used to remove
the trainer's transmitter from your receiver after training).
4.6 Selecting the contact points
Stainless steel contact points are used to ensure the transmission of stimulation
impulses from the receiver to the dog's skin. Each package contains two types.
If your dog has short hair, use the short contact points. If you have a dog with
longer or thicker hair, choose the longer ones. Screw the contact points onto
the receiver screws – see figure 1/2 on page 2. Tighten the contact points by
hand. Do not use pliers or other tools to tighten, you may cause irreparable
damage to the product.
EN EN
29