Dog trace d-control Professional Bedienungsanleitung Seite 25

appropriate precautions. d-control emits a certain static electromagnetic field.
The ONE receiver contains a Li-Pol battery. When the receiver is not in use,
the battery must be charged every 12 months. Protect the battery pack/
batteries in the receiver and transmitter from damage by sharp objects and
high temperatures; ignition or explosion could occur. Do not use any battery
other than the original battery for the ONE receiver.
Use a 5–5.5 V DC charging adapter to charge the battery in
the ONE receiver.
Dispose of the used battery or batteries in a designated place.
3. DESCRIPTION OF THE DEVICE
1. Red point for magnet attachment (on/off)
2. Contact points
3. Indication lights
4. Belt
4. RECEIVER PREPARATION
4.1 Inserting (replacing) the battery in the d-control Professional /
d-control Professional mini receiver
1. Use a Phillips screwdriver to remove the 4 screws on the bottom of the
receiver and remove the cap.
2. Insert a CR2 3V lithium battery in the correct polarity (as shown in fig. 2 on
page 2).
3. Check that the rubber seal is seated correctly in the receiver groove. If there is
dirt on the rubber seal, clean it.
4. Replace the receiver cap and screw in all 4 screws with reasonable force.
TIP: It's easier to remove the battery with a small screwdriver that you insert
carefully under the battery edge.
EN EN
(fig. 1 on page 2)
25