Before Use
EN
1. Place the Charging Dock and Connect to an
Electrical Outlet
Place the charging dock on level ground against the wall. Insert the power cord
into the charging dock and plug it into the socket.
Place the charging dock in a location that is as open as possible with a good
Wi-Fi signal.
> 0.5 m
Note:
· Remove any objects that are closer than 1.5 m from the front and 0.5 m from
either side of the charging dock.
· Do not place the charging dock in an area with direct sunlight or where other
objects might block the signal, as this may hinder the robot from returning to
the charging dock.
2. Remove the Protections
9
> 0.5 m
> 1.5 m
3. Install the Side Brush
Side Brush
Click
Side Brush Clip
Note: Install the side brush until it clicks into place.
4. Charge the Robot
When placing the robot, align the charging contacts at the bottom of the robot
with the charging contacts of the charging dock, and the robot will automatically
turn on and start charging.
Note: It is recommended to fully charge your robot before first time use.