Raychem TCON-Csd/20 Betriebsanleitung Seite 14

Alarms
parameter meaning
Low alarm limit
Al.L
as soon as the process value falls below this limit, the alarm message
Al.L
High alarm limit
Al.H
as soon as the process value goes above this limit, the alarm message
Al.H
Alarm hysteresis
A.Hy
The hysteresis that was set is below
Alarm suppression time
Al.d
an alarm from
is present for longer than
Response to over/underrange
S.Er
0: relay de-energized
1: relay energized
14 / 72
is displayed, see Chapter 7 "alarm messages".
is displayed, see Chapter 7 "alarm messages".
Al.L Al.H
or
Al.d
Raychem-IM-INSTALL100-TCONCSD20-EN-1703
Al.H Al.L
or above
is not displayed for this time. if an alarm
, then it will be displayed.
value range
from...factory-set...to
-999 ... –200 ... +999
-999 ... 500... +999
-999 ... 1.0 ... +99.9
.
0 ... 60 min
0, 1
INDUSTRIAL HEAT TRACING SOLUTIONS