Electrolux WASL6E202 Benutzerhandbuch Seite 27

Message
The display tells to check
the drain filter: the appli-
ance does not drain the
water.
The display tells to check
the door.
The display tells there is a
water alert.
The display tells that the
main supply is unstable.
Problems without alarm messages
Problem
The programme does not
start.
The appliance does not
drain the water.
The appliance fills with
water and drains immedi-
ately.
The spin phase does not
operate or the washing cy-
cle lasts longer than usual-
ly.
Possible solution
Make sure that the connection of the water inlet hose is
correct.
Make sure that the drain hose is not damaged.
Make sure that the drain filter is not clogged. Clean the
filter, if necessary. Refer to 'Care and cleaning'.
Make sure that the connection of the drain hose is cor-
rect.
Make sure that the appliance door is not open or closed
correctly.
The anti-flood device is activated:
• Disconnect the appliance.
• Close the water tap.
• Contact the service centre.
Wait until the mains supply is stable. The appliance au-
tomatically starts operating.
Possible solution
Make sure that the mains plug is connected to the
mains socket.
Make sure that there is not a damaged fuse in the fuse
box.
Make sure that the you have touched Start/Pause - Dé-
part/Pause.
If the delay start is set, cancel the setting or wait for the
end of countdown.
Deactivate the Child Lock function if it is on.
Make sure that you have not set a programme without
drain phase.
Make sure that you have not set an option which ends
with water in the tub.
Make sure that the drain hose is in the correct position.
The hose may be too low.
Make sure that the spin phase is not off.
ENGLISH 27