Texi Bro Benutzerhandbuch Seite 9

KNOWING YOUR SEWING MACHINE
Seam guide line
The numbers on the needle plate indicate
the distance between the center needle
position and the indicating line.
The numbers in the front indicate in
Millimeters.
The numbers in the back indicate in inches.
Setting spool pins
The spool pins are used for holding the spool of thread in order
to feed thread to the machine.
To use, pull up the spool pin. Push down for storage.
NOTE: In case of using thread which has tendency to tangle around the spool
pin, thread through the hole of spool pin as shown. The hole should face
to the thread spool.
Winding the bobbin
1.Place a spool of thread on the spool pin. pull the
thread out from the spool,through the hole of spool
pin and place it through thread guide as shown in
illustration. Put end of thread through the hole in
bobbin as shown.
2.Push the bobbin wider shaft to far left position, if
it is not already there. Place bobbin onto the
bobbin wider shaft with end of thread coming
from top of bobbin. Push bobbin winder shaft to
the right until it clicks. Hold onto end of thread.
3.Start machine. Bobbin will automatically stop
turning when completely filled. Push shaft to the
left to remove bobbin and cut thread.
Upper thread Hole
9
Tangle