LORD R2 Bedienungsanleitung Seite 40

Troubleshooting
CAUTION! Before troubleshooting, disconnect the power supply. Only a qualified
electrician of m competent person must do the troubleshooting that is not in this
manual.
IMPORTANT! There are some sounds during normal use (compressor, refrigerant
circulation).
Problem
Appliance does
not work
The food is too
warm
Appliance cools
too much
Unusual noises
Water on the
floor
Side panels are
hot
If the fault reappears, contact an authorized service center.
Contact the authorized service can be found at www.lord.eu.
Possible cause
Temperature regulation
knob is set at number "0".
Mains plug is not plugged in
or is loose.
Fuse has blown or is
defective.
Socket is defective.
Temperature is not properly
adjusted.
Door was open for an
extended period.
A large quantity of warm
food was placed in the
appliance within the last 24
hours.
The appliance is near a heat
source.
Temperature is set too cold.
Appliance is not level.
The appliance is touching
the wall or other objects.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
Water drain hole is blocked.
It's normal. Heat exchange
parts are in the sides.
Solution
Set the knob at other number
to switch on the appliance.
Insert mains plug.
Check fuse, replace if necessary.
Mains malfunctions are to be
corrected by an electrician.
Please look in the initial
Temperature Setting section.
Open the door only as long as
necessary.
Turn the temperature
regulation to a colder setting
temporarily.
Please look in the installation
location section.
Turn the temperature
regulation knob to a warmer
setting temporarily.
Re-adjust the feet.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.
Seethe Cleaning and Care
section.
Take gloves to touch sides.
19