Saeco Intelia Deluxe HD8904 Bedienungsanleitung Seite 25

The coffee comes out
slowly.
The milk does not froth.
The AquaClean filter
cannot be activated as
the tick does not appear
on the display.
The filter cannot be
activated and the
machine asks for
descaling.
The AquaClean filter is
installed, but the
descaling message
appears.
The descaling message
appears before 8 filters
were replaced.
The grind is ground too finely.
The brew group is dirty.
The coffee exit duct is blocked.
The machine circuit is blocked by
limescale.
The automatic milk frother is
dirty or not assembled or
installed correctly.
The type of milk used is not
suitable for frothing.
A filter has just been activated.
You have already replaced 8
AquaClean filters. After 8 filter
replacements you need to
descale the machine.
The filter has not been replaced
in time after the AquaClean
water filter signal started
flashing.
The filter has not been installed
during first installation but after
having brewed approx.50
coffees (based on 100ml cups).
The machine has to be
completely limescale-free
before installing the AquaClean
filter.
The AquaClean filter was not
correctly activated during first
installation.
After 8 filter replacements, you
need to descale the machine
You did not activate the
AquaClean filter correctly during
first installation.
Change the grinder to a coarser
setting.
Clean the brew group.
Clean the coffee exit duct with the
handle of the multifunctional tool or a
spoon handle.
Descale the machine.
Clean the automatic milk frother and
make sure it is correctly assembled or
installed.
Different types of milk result in
different amounts of froth and
different froth qualities. Semi-skimmed
or full-fat cow's milk give good results.
You have to dispense at least 10 cups
(of 100ml each) before you can
activate a new filter. Be careful as you
activate a new filter, the filter counter
will increase automatically.
Descale your machine first and install
the filter.
Descale your machine first and install
the filter.
First descale the machine and then
install a new AquaClean filter. After
descaling, the filter counter is reset to
0/8. Always confirm filter activation in
the machine menu, also after filter
replacement
Follow the instructions on the display
until you receive confirmation that the
filter has been activated.
First descale the machine and then
install a new AquaClean filter. This will
reset the filter counter to 0/8. Always
confirm filter activation in the machine
menu, also after filter replacement.
First descale the machine and then
install a new AquaClean filter. Always
activate the filter in the machine menu.
English
25