Silvercrest RHYTHM GO Bedienungs- Und Sicherheitshinweise Seite 34

NOTE: Only SilverCrest branded Bluetooth speakers with
this PartyPlay function can work together.
NOTE: The product which had its PartyPlay
pressed first will become the "primary" unit and the other unit
will then by default become the "secondary" or "additional"
unit. The playback device can only be controlled with the
primary device.
To enjoy the Partyplay function, you can connect more Partyplay
compatible products together and up to 10 speakers can be
connected together by using the Partyplay
Step1: Turn on a loudspeaker which will then by default be set
as the "primary" device and then connected to the playback
device via Bluetooth first. A beep sound will emit out and the
LED 6 will flashes white approx. every 5 sec once connected
successfully.
Step2: Press and hold for 2 seconds on the PartyPlay
button 9 of the primary device until the signal tone sounds
emitted and LED 6 will stay on during PartyPlay pairing.
Step3: Press briefly the PartyPlay
device, the LED 6 of the second speaker will breathing
white and a signal tone sounds will emit out once connected
successfully. You can now control synchronously during
Bluetooth playback mode.
To integrate additional speakers, the Partyplay
9 must be pressed once on the additional speakers. Make
sure all the speakers must all be within Bluetooth range
approx.10m.
Press and hold the Partyplay
break the Partyplay pairing connection, the LED 6 on the
connected secondary/ additional units flash and a signal
tone sequence sounds.
˜ Cleaning
Switch the product off and remove all cables before
cleaning.
Only clean the outside of the product using a clean, dry
cloth for cleaning the product and never use any corrosive
liquids / abrasive cleaning agents. Use a slightly moistened
cloth and a mild cleaning agent to remove stubborn dirt.
When cleaning the speaker, the USB/AUX-IN cover should
be closed.)
button 9 .
button 9 of second
button 9 again to
button 9
button
GB/IE 35