Silvercrest STV 30 A2 Bedienungsanleitung Seite 11

Electrical safety
m WARNING! Risk of
injury! Switch the product
off and disconnect it from the
power supply before cleaning
work and when not in use .
m WARNING! Risk of
electric shock! Ensure
the rated voltage shown on
the rating label corresponds
with the voltage of the power
supply .
m WARNING! Risk of
electric shock! If the supply
cord is damaged, it must be
replaced by the manufacturer,
its service agent or similarly
qualified persons in order to
avoid a hazard .
Operation
m CAUTION! Risk of injury!
Never use the product without
the safety grille or with a
damaged safety grille .
m CAUTION! Risk of injury!
During use, keep hands, hair,
clothing and utensils away
from the safety grille to avoid
injuries and damage of the
product .
Only use the product in dry
indoor rooms .
Protect the product, its power
cord and power plug against
dust, direct sunlight, dripping
and splashing water .
˜ Before use
˜ Unpacking
Remove the packaging . Check if all parts are
o
complete .
˜ Assembly
Fig. Step
A+B Place the stand
stable ground .
Push the base unit
the stand .
[ 8 ]
C
Remove the grille lock nut
drive shaft .
Place the rear grille
shaft of the base unit
Secure the rear grille
lock nut .
4 ] [
D
Place the blade
of the base unit
Secure the blade
lock nut .
[ 2 ]
E
Open the locking clips
grille . Align the screw holes
1 ] [
the bottom side of front grille
rear grille . Make sure the clip
[ 5 ]
well positioned .
F
Secure the front grille
down the locking clips
grille .
[ 5 ]
G
Lock the front grille
grille with the screw and nut
5 ] [
on a flat,
8 ] [
onto
7 ] [
from the
4 ] [
on the drive
5 ] [
.
[ 7 ]
with the grille
5 ] [
on the drive shaft
[ 3 ]
.
7 ] [
with the blade
[ 3 ]
on the front
11 ] [
on
12 ] [
and
[ 1 ]
is
10 ] [
by pressing
[ 1 ]
on the rear
11 ] [
and the rear
[ 1 ]
.
9 ] [
GB 9