Hendi 2000 Gebrauchsanweisung Seite 7

On the other hand, if you have pressed temperature key
in temperature mode operation, the default temperature is 100
Note! If the appliance beeps after being switched on, the pan you are using is not
suitable for induction or the appliance is defective. In case of any doubt, always
contact the supplier of your pan !
Once the appliance is operating, it enters the Capacity mode by default, and the
display indicates position "100", you can programme the appliance in one of the
following ways.
Capacity mode: You can control the performance of the appliance, just as for a
•
gas cooker via 11 positions ranging from 100W to 2000W
Temperature mode: you can set the temperature between 35
•
increments. Standard position for the appliance is 100
NOTE: if we keep pressing the arrow keys, the SET temperature increases in a
fast speed
Attention! The programmed temperature is that of the glass plate and not the
temperature in the pan !
§ Capacity Mode: If you choose capacity mode, press the "Power key"
the "Power key"
programme the capacity required by means of the arrow keys
the highest and 100W the lowest position
§ Temperature Mode: If you select the temperature mode, press the "Temperature Key"
, the lighting of the "Temperature key"
will be switched on. Default Capacity is 100W. Now you can
, the appliance will enter
C
o
o
C.
o
&
will be switched on. Default Set
C and 240 C in 5 C
o o
, the lighting of
, 2000W being
7
EN NL