Kickstand - Mantis Deluxe XP 7567 Bedienungsanleitung

LOwER HANdLE ASSEMBLy
7
• Slide the left loop handle into the
foam grip and right loop handle.
10
• Use the 7 /16" (11 mm) spanner
and socket to tighten the rest of the
handle bolts.
KIcKSTANd ASSEMBLy
1
Contact us at www.mantis.uk.com or your local authorised Mantis
(cONTINUEd)
8
• Slide loop handle through bolts
and over top lower left handle,
then take two lock nuts and
fasten them finger tight.
11
2
• Position the kickstand bracket
just below the upper bend of
the lower handles. The stamped
arrow should be pointing up.
• Position the kickstand under the
lower handles, line up the holes
and thread the kickstand bracket
bolts into the kickstand.
• Tighten with the 3/8" (9 mm)
spanner.
Assembly
9
• Place the carry handle between the
lower handles and line up the holes
• Place two of the 1.125" (28 mm) bolts
through holes with hex head on inside
of carry handle and with two lock nuts
fasten them tight with spanner and
socket.
• At this point, your Mantis
Tiller should look like this when lower
handle assembly is complete.
3
• Your Mantis Deluxe XP
®
Tiller will look like this when
lower handle assembly and
kickstand is complete.
Dealer
®
Deluxe XP
®
9