Mantis Deluxe XP 7567 Bedienungsanleitung Seite 15

HOw TO SwITcH FROM TILLING TO cULTIVATING POSITION
1. First, you will need to understand that
your Mantis Deluxe XP Tiller has an
®
inner and an outer set of tines on each
side of the tiller as shown in Figure 1.
2. Make sure the tiller is turned off.
3. Remove the retaining pins from the
outer set of tines (Figure 2) and
remove the outer tines.
4. Only after you have removed the outer
set of tines, then remove the retaining
pins from the inner tines and remove
the inner tines from the transmission
axle (Figure 3)
5. Place the right-side set of inner tines
onto the left-side. The "D" shaped
IMPORTANT:
To change the tines on your
Mantis deluxe XP Tiller, push the
®
tiller forward and allow it to rest on
the loop handle.
Contact us at www.mantis.uk.com or your local authorised Mantis
hole should be to the outside. Make
sure the tine retaining pin is installed.
Repeat for the other side
6. Place the right side set of outer tines
onto the left-side axle. The "D" shaped
hole should be to the outside and
insert the tine retaining pin. Repeat for
the other side.
Your Mantis
the ability to till or cultivate at either a 9"
or 16" (41 cm) width. The tiller is sent to
you set up for 16" (41 cm) . To run the
tiller at a 9" (23 cm) width, simply remove
the inner and outer tines as noted above.
Then just put the outer tines back onto
Figure 1
Inner Tines
Outer Tines
Tilling
Handles
back
To set them for tilling, attach the tines
so the points of the blades face forward
- away from the operator. The tines'
points will contact the ground first.
Mantis Deluxe XP Tiller Operation
®
Deluxe XP Tiller also has
®
Figure 2
Tine
Rotation
Tine Teeth
Front
the transmission axle and secure with a
retaining pin on each side.
DO NOT reach your fingers and/or
hand between the tine blades.
dO NOT attempt to remove the
inner set of tines until you have
first removed the outer set of tines.
Figure 3
cultivating
Handles
back
For cultivating, reverse the tines
so that the points of the tines face
backward - toward the operator. Now
the long flat part of the tine's blade
will contact the ground first.
Dealer
®
Tine
Rotation
Tine Teeth
Front
15