Sharp ER-A550 Installationsanleitung Seite 15

@ Activation
The program is activated by JOB#501~507.
SRV mode: 501 ~> TL: Channel 1
502 ~» TL: Channel 2
503 -3 TL: Channel 3
504 — TL: Channel 4
505 ~» TL: Channel 5
506 - TL: Channel 6
507 ~> TL: Channel 7
® Contents to be tested
if the channel specified by JOBACODE is not set, the machine
performs the mis-operation processing. When the channel is set,
the machine conducts the loop check concerning the channel
specified by JOB#CODE by using the loopback connector.
(}) Control signal check
@) Data transfer check
@ Timer check (RS232 onboard timer)
ED one by one. (The mask is released.)
Check @ Timer check
Before making check @, set the corresponding timer at
{O0ms for RCVDT activation, and check to see that:
1) TROT is not generated during the execution of check
@.
2) THOT is generated in 10msec. after check @ is
finished.
® Contents to be checked
~14~
ER-A550IM
RSa-CDn ERB
RSn-CSn ERR
Interruption error of Cin
E4-RS CS
[5 escrint
2
E11-TXRDY | Interruption error of TXRDYn
E12-RCVRADY | ROVRDYn error
®.)
E13-RCOVRDY | | Interruption error of RCOVRDY
(Reception is impossible. TRQ1t has
E14-SD RD SDn-RDn ERR
occurred during execution of check
(Data error)
(Data error)
£16-TIMER TIMERn error
16
be set
termination of check @.)
(TMRGin cannot
E17-TIMER | | Interruption error of TRO1
@ Cancellation
The program automatically terminates when a check is finished.
after
Termination print-out:
no: 1~7
50n