Sharp ER-A550 Installationsanleitung Seite 9

EEE
ER~AS550IM
2) To install two interface PWB's, follow the next steps. (When in-
3. Installation procedur
Installa
proce
€
stalling the ER-ASIN and the ER-A5RS)
1) Connect the internal cable to the interface PWB unit and secure it
@ Insert two spacers @ and connect the connectors of the interface
with the connector screw, and install the care on each cable.
PWB together (Fig.3).
@ In-Line cable
* Make sure the spacer is mounted properly to insure proper
connection.
(b) LX-B26774RCZZ
RCOORF1016LCZZ
Fig. 1
* Be sure to install the core (RCORF1018LCZZ)
on the inline
cable. (Fig. 1)
®) RS232 cable
Be es
Fig. 3
3) Remove two rear cover holding screws and remove the rear cover
@ (Fig.4).
* The interface PWB needs to be inserted into the left side slot
as seén from rear.
x Tilt up the popup dispalay when removing the rear cover.
RCORF6E Zz
sca
4) Break open the knockout @ of the rear cover
@ (Fig.4).
After beraking opan the knockout @, file off the new hole.
Fig. 2
5) Insert the interlace PWB @ onto the connector of the main PWB
_ © Be sure to Install the core (RCORF66S8RCZZ) on RS-232C
@, and fasten the bracket to the main chassis using screws ©
(LX-BZ6774RCZZ: Self tap screw) (Fig.4).
cable. (Fig. 2)
win