Vitek VT1832 R Betriebsanweisung Seite 9

ENGLISH
•
Wash the "cyclone" filter (23) under a warm
water jet and dry (pic.14).
•
Wipe the separator (24) with a damp cloth.
Note: To avoid damaging of the separator
(24), do not wash it under a water jet.
•
Put the "cyclone" filter (23) on the separator
(24) and turn it until the " "marks shift.
•
Put the lid (21) on the separator (24), matching
the edges on the separator with the grooves
on the lid, and turn it clockwise (pic.11).
•
Set the filter unit (10) into the container (9).
•
Set the container (9) into the body of the
unit.
•
Close the lid (5).
Cleaning the input filter (6), the output foam
filter (18) and the НЕРА-filter (17)
•
Switch off and unplug the unit.
•
Open the lid (5), pulling the lid opening but-
ton (7) (pic.1).
•
Remove the input filter (6), wash it under
slightly warm water, dry thoroughly and place
on its place (pic.15, 16).
•
Open the lid of the output filter (19), by press-
ing the clamp lid, remove the НЕРА-filter (17)
and the output foam filter (18) (pic.17).
•
Wash the НЕРА-filter (17) and the foam filter
(18) under a slightly warm water jet, dry thor-
oughly and place on its place (pic.17).
•
Close the lid (19).
Body of the vacuum cleaner
•
Wipe the body of the vacuum cleaner with a
damp cloth.
VT-1832 R B.indd 8 VT-1832 R B.indd 8
•
Do not allow liquid to get inside the body of
the vacuum cleaner.
•
Never use solvents or abrasive cleaning
products to clean the surface of the vacuum
cleaner.
•
Keep the unit in a dry cool place out of reach
of children.
Specifications
Power supply: 220 -240 V~ 50 Hz
Power consumption: 1800 W
Suction power: 300 W
The manufacturer preserves the right to change
the design and specifications of the unit without
a preliminary notification.
Service life of the unit is at least 5 years
Guarantee
Details regarding guarantee conditions can be
obtained from the dealer from whom the appli-
ance was purchased. The bill of sale or receipt
must be produced when making any claim under
the terms of this guarantee.
This product conforms to the EMC-Re-
quirements as laid down by the Council
Directive 89/336/EEC and to the Low
Voltage Regulation (73/23 EEC)
8
05.08.2011 15:36:08 05.08.2011 15:36:08