Do not use solvent-containing cleaning agents like petroleum
CAUTION!
Clean the housing of the receiver using a dry cloth.
9 Transport and Decommissioning
Proceed as follows if you want to transport the receiver of if you do not
want to use the receiver any more:
1. Disconnect the receiver and all connected devices from power supply.
2. Disconnect any cables connected to the receiver.
3. Remove the batteries from the remote control.
4. Put receiver, cables and remote control into the original packaging.
5. Store the receiver and the accessory parts at a dry and dust-free location.
6. Protect the receiver from freeze.
10 Troubleshooting
This section includes a list of general errors that could occur with operation of
the receiver. Each error states a possible cause and solutions.
Symptom
The display does not
light.
No audio or video;
the receiver states
"OFF" and the red
LED lights up.
AVANIT SXHD
There is the risk of damaging the receiver when
cleaning the receiver!
ether or thinner.
Possible cause(s)
The power cord is not con-
nected.
The power switch is not
switched on.
The receiver is in standby
mode.
Transport and Decommissioning
Solution
Connect the power cord to the
power outlet.
Switch on the power switch.
Press the POWER key to switch on
the receiver.
131