Herunterladen Inhalt Inhalt Diese Seite drucken

Switching Off The Oven; Safety Procedures; Temp 1; Temp - GGMgastro DPZ3030E Bedienungsanleitung

Umluft tunnelofen
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

7.5. SWITCHING OFF THE OVEN

Press the key
The heating stops while the air recycling fan and mesh continue working, if
on, until the temperature drops below 150°C. After this the main contactor
de-energizes leaving only the circuit board powered to feed the clock and
programmed switching on functions.
During the switching off phase the rear illumination remains on and the word
"OFF" flashes. During this phase the oven can be switched back on and the
mesh can be started or stopped.
To prevent the oven being accidentally switched on, check the display
indicates the precise desired day and time of switching on, or, if automatic
switching on is not desired, that the words "start: off" appear.

7.6. SAFETY PROCEDURES

The functioning of the oven is continually checked, setting off an alarm
procedure if any faults arise.

7.6.1."TEMP 1"

If the temperature measured by probe 1 exceeds 350°C or if the probe
breaks, the temperature value on the display is replaced by the flashing
phrase "TEMP 1" and the alarm intermittently sounds.
Switch off the alarm by pressing the key
The oven continues working and only probe 2 is used to measure the
temperature. The control temperature is also automatically decreased by
40°C.
This variation in the temperature corrects the only value read in the hottest
part of the oven and simulates an approximate value to the effective value
which was previously set by supplying the average of values between the
hottest and coldest points. This allows the oven to be used even when a
probe breaks.

7.6.2."TEMP 2"

If the temperature measured by probe 2 exceeds 450°C or if the probe
breaks, the temperature value on the display is replaced by the flashing
phrase "TEMP 2" and the alarm intermittently sounds.
Switch off the alarm by pressing the key
The oven continues working and only probe 1 is used to measure the
temperature. The control temperature is also automatically raised by 40°C.
OPERATION - ELECTROMECHANICAL VERSION
to switch off the oven.
Synthesis 05/40V
.
.
21

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis