Hensel Eh mini P Led Speed Blitzkopf Bedienungsanleitung Seite 25

HENSEL-VISIT GmbH & Co. KG
 Do not route cables across the studio floor if possible,
so that damage is excluded. If routing across the studio
floor cannot be avoided, then it must be ensured that
vehicles, ladders, etc. do not damage cables.
Damaged cables and cases must be replaced
immediately by customer service.
 Do not stick any objects into ventilation slots. Venti-
lation slots of the flash head must be kept free during
operation and sufficient air supply must be ensured.
Do not deposit any objects (tools, clothes, etc.) on the
flash head.
 Flash systems must not be used in environments with
explosion hazard.
 Flammable materials, like furnishing fabrics, paper,
etc. must not be stored in the immediate vicinity of
flash heads to prevent fire hazards.
 Protect the equipment from moisture (including snow
and ice), dripping or splashing water.
 Choose safe locations for set-up and make sure that
the equipment cannot fall into pools or bodies of water.
Never run cables directly along or even through pools
or bodies of water.
 Do not connect accessories from other manufacturers,
even if they use the same or similar connectors.
 Flash heads - hanging from pantographs or ceiling -
must be doubly secured against falling down.
 Do not flash into eyes at short distances (smaller than
5 m), because this can lead to eye damage.
 Do not look directly into the flash reflector, the flash
lamp could be triggered inadvertently.
 Regularly air closed rooms to prevent build-up of inad-
missible ozone concentrations, which can occur due to
the use of high-powered flash systems.
 During work in the studio generating much dust, the
appliance must be covered with suitable dust pro-
tection (not during operation).
User manual // EH Mini P LED Speed Flash Head
25