Hameg HM8131-2 Handbuch Seite 49

However, if you now look at the Hz – display you will
notice that there was a 7 to the right of the decimal
point, the cursor will come below the same 7 in the
kHz – display.
STOP
Input via the menu pushbutton group
Go to the basic menu using the keyboard
following display:
Fr. 1.0000000 kHz
Sin Tri Sqr -->
Push button [1] of the keyboard • and enter the
value shown by pushing button kHz/mV."
HINT
Push button [FREQ] inorder to activate the frequencefunction.
The display will show the following:
Fr: 1.0000000 kHz
-val+ <cur>
Below the display there are the menu buttons
a b
and correspond with the display function – val +. With
the two buttons below the – and + symbols the value indicated
by the cursor can be decreased resp. increased. The buttons
c d
and belong to the cursor function < cur > and move the
cursor left or right.
In the following example the value 102.56 kHz is entered:
FR: _1.0000000 kHz
-val+ <cur>
c
a b
c
Push the button in button group
move the cursor 2 positions to the left.
FR: 101.0000000 kHz
-val+ <cur>
c
a b
b
Now push the button below the symbol + once. The display
will now show:
FR: 102.0000000 kHz
-val+ <cur>
c
a b
Now move the cursor one position to the right. Use button
to select the 5. Move the cursor again one position to the right
b
and use button to select 6. This will yield the desired dis-
play.

•
so you will get the
g
e
f h

. The buttons
d

below the symbol < and
d
d

S t r u c t u r e a n d u s i n g o f t h e m e n u s
FR: 102.5600000 kHz
-val+ <cur>
c
a b
Holding + resp. – depressed will automatically
increase resp. decrease the value. It is hence un-
necessary to repeat pushing these buttons in order
to increase or decrease. This allows a fast change
of values. Of course, the amount of increment resp.
STOP
decrement is determined by the position of the
cursor.
"You can enter 150 kHz just by remaining e.g. in the
th
1/100 position, but it will cost your time. Moving
the cursor by 3 positions to the left in order
to enter the 5 will speed matters up."
HINT
”
Input via the knob
Select the basic menu using the button group
following display:
Fr. 1.0000000 kHz
Sin Tri
1 2 3 4
e
Push button [FREQ] in order to call up the frequency function,
the display will show:
Fr: 1.0000000 kHz
-val+ <cur>
Below the display there is the button group
c d
tons and ,associated with the display function < cur >,
the cursor can be moved. As an example the value 102.56 kHz
shall be entered:
FR: _1.0000000 kHz
-val+ <cur>
c
a b

c
Push button of group
cursor 2 positions to the right. Now turn the knob
clockwise until you get this display:
FR: 101.0000000 kHz
-val+ <cur>
a c
b
Should you have gone too far turning the knob
counterclockwise will get you there.
HINT
d

so you get the
Sqr -->
g
e
f
5 6

. With the but-
d
below the symbol < and move the
”
d
Subject to change without notice
h
softly
47