Connecting To A Power Supply; Inserting Batteries; Fm Wire Aerial - Silvercrest SKR 800 B2 Bedienungsanleitung

Connecting to a power supply

CAUTION
► Before connecting the device, compare the connection data of the device
(voltage and frequency) on the rating plate with that of your electrical
supply. This data must match so that the device is not damaged.
♦ Insert the power plug into a mains socket. The device starts an automatic
station search and saves the stations that can be received in the max. 20
preset slots.
there is a suitably strong RDS signal, the time and date will be set automat-
ically. If the RDS signal is too weak, the time display (
display

Inserting batteries

You can prevent the programmed time or preset stations from being lost in the
event of a power outage by inserting 2 x 1.5 V batteries (type AA/Mignon/LR6).
The batteries ensure that the internal clock continues to run even during a power
outage. The display
time automatically appears on the display.
NOTE
► The device can also be operated without batteries. The display, radio and
alarm do not function in emergency mode.
► In the event of a power failure, all settings will be lost.
♦ Open the cover of the battery compartment
♦ Insert 2 x 1.5 V batteries of the type AA/Mignon/LR6 (not included in the
product) into the battery compartment. Insert the batteries in the battery
compartment as shown on the polarity diagram.
♦ Then close the battery compartment by replacing the cover and clicking it
into place.

FM wire aerial

♦ Completely unwind the wire aerial
SKR 800 B2
(RDS (radio data system)) flashes briefly on the display. If
and the time and date must be set manually.
will go out, however. When power is restored, the correct
) appears on the
on the bottom of the device.
for FM radio reception.
33 ■
GB
│