Powering The Locator On And Off; Adjusting The Volume / Using Headphones; Localizing The Camera Head; Localizing Visually - Wohler L 200 Bedienungsanleitung

5.1 Powering the Locator
on and off
5.2 Adjusting the volume /
using headphones
5.3 Localizing the
camera head
5.3.1

Localizing visually

Fig. 10. Localizing the camera head
•
To power on the Locator, briefly press the
On/Off key (Fig. 1, position 2).
•
When the Locator is powered on, the top part
of the light framing the On/Off key lights up
green.
The display powers up after about two seconds.
•
To power off the Locator, press and hold the
On/Off key for about one second.
An acoustic signal provides a clear indication of
the distance between the Locator and the camera
head. The closer the Locator gets to the camera
head, the more intensive the signal becomes.
•
Press the + key to increase the volume.
•
Press the – key to reduce the volume.
The acoustic signal is only available through the
headphones as soon as you connect headphones
to the headphone socket of the Locator.
NOTE!
It is possible to switch off the transmitter in the
camera heads VIS 250 and VIS 350. When work-
ing with this system, make sure that the transmit-
ter is switched on before beginning the localizing
procedure (please refer to the operating manual
Wöhler VIS 200/250/300/350, chapter "Making
settings via the menu".
The transmitter in the camera heads Wöhler VIS
200/300 is permanently switched on.
The position of the transmitter is depicted on the
virtual plane immediately after the Locator is pow-
ered on.
The intensity indicator indicates the strength of the
signal being received on a scale between 0 and
100.
12BOperating the Locator
EN
23