Herunterladen Inhalt Inhalt Diese Seite drucken

Charging The Storage Battery; Using The 12 V Vehicle Outlet; Replacing Fuses - AEG LA 10 Betriebsanleitung

Luft- und energiestation
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
24

4.4 Charging the storage battery

Charging by 230 V charging mains adapter
The storage battery should be fully charged prior
to first use.
▪ Connect the small round plug on the charging
mains adapter
to the receptacle
10
▪ Plug the charging mains adapter into a 230 V
power socket.
▪ Set the operating switch
now switch to charging mode.
▪ The LED display
will light up and the blinking
20
LED will indicate the current storage battery
capacity. The charging time is approx. 10 - 12
hours. The green LED must stay on when the
storage battery is fully charged.
▪ After charging use the operating switch to
power the unit off and disconnect the 230 V
charging mains adapter from the unit and the
230 V outlet.
Note! Do not operate the compressor or
the light whilst charging!

4.5 Using the 12 V vehicle outlet

▪ Remove the cover from the 12 V vehicle jack.
▪ Connect the 12 V vehicle plug of the external
device to the unit's 12 V vehicle jack.
▪ Set the operating switch
13
External device
12 V vehicle
plug
Image 7
.
14
to ( I ). The unit will
13
to ( I ).
13
16
▪ The unit's 12 V vehicle jack is now live and the
connected 12 V external device can be oper-
ated (see Image 7).
▪ After using the external device unplug the 12 V
vehicle plug from the 12 V vehicle jack on the
unit.

4.6 Replacing fuses

12 V Vehicle plug
Retaining screw
Round fuse 15 A (Ampere)
Terminal cap
Image 8
▪ Unscrew the retaining screw.
▪ Remove the terminal cap and the 15 A
(Ampere) round fuse.
▪ Assemble all parts with the new 15 A fuse in the
order shown and replace the retaining screw
(see Image 8).
Fuse
Image 9
▪ Using a pair of flat-nose pliers carefully pull the
flat fuse inside the housing unit for the controls.
▪ Replace the defective fuse with a new 15 A flat
fuse by carefully pushing the new fuse into the
fuse holder with your thumb until it is flush with
the unit housing (see Image 9).
12 V vehicle
connector plug
Intact flat fuse
15 A (Ampere)

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis