eta ellen Bedienungsanleitung Seite 18

EN
• Recommendation: If you are not using the kettle, do not place it on the stand connected
to the electrical outlet sewing.
• If you are heating the water to a lower temperature (40 - 70 °C), it is advisable to have
at least 0.7 l of water in the kettle to more accurately reach the selected temperature.
With a lower amount, the water temperature may exceed the temperature you have set.
• Without the kettle on the base, the electronic control does not respond.
• If you set the heating temperature lower than the current water temperature, the kettle will
turn off.
• If you are preparing food for small children (e.g. at 40 °C), you must first boil the water to 100 °C.
• The temperature sensor is located in the lower part of the kettle and due to the different
temperatures at the bottom and at the surface, the temperature is displayed with a certain
tolerance.
• After approx. 20 min. of inactivity, the kettle switches to sleep mode (the display turns off).
Press B1 or B3 to wake up. Standby mode (i.e. sleep) cannot be activated by any buttons.
WARNING: If the kettle is switched off and the B2 button is pressed, the reheat function is
immediately activated (to the temperature that was last set), with subsequent maintenance
of this temperature.
KEEP WARM
Press to switch B3 to select the desired heating temperature (40-50-60-70-80-90 °C) in the
classic way. Press B2 to switch and the heating + the KEEP WARM function will start. The B5
and B6 icons will on lit. After preset temperature has been reached, sound signal will be given
and the maintaining temperature function will be activated automatically (display shows the
water temperature and signal lamp B6 will light continuously). This function will remain active for
approx. 2 hours, then the device will be switched off automatically (sound signal will be given).
After 20 minutes of inactivity, the kettle switches off automatically (the display goes out).
Memory (for Keep Warm function)
The electric kettle is equipped with memory function. It can be used if the kettle has been switched
on and the Keep Warm function active. If the kettle will be removed from its base in the Keep
Warm mode, it will continue keeping the temperature. If the water temperature with the range of
± 5 °C of choosed temperature. Reminder: There is no memory function under cooking mode.
• If you set a lower temperature than the current temperature and the KEEP WARM function is
active, the kettle will maintain the temperature at the set value (ie. two short signal sounds,
the appropriate signal light indicator B6 will start flashing. The kettle wait until the water
temperature drops to this value and continue to maintain it).
• Water heating, including the KEEP WARM function, can be interrupted at any time by pressing
button B1 or B2 or by lifting the kettle from the base.
IV. MAINTENANCE
Unplug the appliance from power supply by taking the fork of the power cord out of the
socket! Clean the kettle only when it is cooled down!
ATTENTION
Note
Note
EN - 18