Siemens SIMATIC HMI Betriebsanleitung Seite 33

Fastening the connecting pipe, wiring operator controls and sealing the cover
1. Slide the sealing plate into the recess of the basic adapter and use two countersunk
2. Fit the flange using the cylinder screw M4x12 supplied in the accessory pack.
3. Wire the cable in the extension unit enclosure with the operator controls that you installed
4. Close the cover of the extension unit.
5. Fasten the cover with six countersunk screws M4x12 supplied in the accessory pack.
Result
The extension unit is fully installed.
Extension Units
Operating Instructions (Compact), 02/2009, A5E02296499-01
screws M4x12 supplied in the accessory pack to fit the sealing plate.
in the cover of the extension unit.
Installation and connection
4.2 Installing the extension unit
33