Preparation; Control Elements; Attaching And Removing The Motor Head; Assembly - Parkside Performance PPWD 30 A1 Originalbetriebsanleitung

GB MT
Remove the battery from the
•
appliance before storing it.
Replace worn or damaged
•
parts in the interests of safety.
Use only original spare parts
and accessories. Using extern-
ally produced parts results in
the immediate loss of any war-
ranty claim.
The device may only be
•
opened by an authorised
electrician. Always contact
our service centre for repairs.
Switch the drive off, discon-
•
nect the device from the
power supply and allow the
device to cool off if you want
to clean, adjust, store the
device or to exchange an ac-
cessory part.
Handle the device with care
•
and keep it clean.
Store the device out of reach
•
of children.

Preparation

WARNING! Risk of injury due to un-
intentional start-up. Do not insert the plug
into the outlet until the device is fully pre-
pared for use.

Control elements

Familiarise yourself with the operating ele-
ments before using the device for the first
time.
32
On/Off switch (3)
The appliance has two operating modes.
• OFF: Appliance is switched off.
• ON: Appliance is switched on.
• AUTO: Appliance starts automatic-
ally when a connected power tool is
switched on.
Volume flow controller (2)
• MIN: Minimum volume flow
• MAX: Maximum volume flow
Attaching and removing the
motor head
Disassembling the motor head
1. Unlock the snap locks (13) on the dirt
container (15).
2. Take the motor head (12) off.
Assembling the motor head
1. Place the motor head (12) on the dir-
ect container (15). The control panel
points to the suction connection (19).
2. Lock the snap locks (13) on the dirt
container (15).

Assembly

Sticking on a warning label
The appliance must be provided with a
warning label.
1. Peel off the warning label (25) in your
national language from the enclosed
sticker sheet and stick the warning la-
bel on the marked area.