Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation Guide
If camera power will be supplied via the terminal connector:
6. Make sure that your power supply meets the camera power requirements
stated in Table 1 on page 30 and the wire size requirements stated on
page 29.
7. Obtain the black, 8-pin Weidmüller plug that was shipped with the camera.
8. Using the technique described on page 29, insert the ground wire from the
power supply into pin 1 of the plug and the positive wire into pin 3.
The positive wire is typically marked with a white stripe, a colored stripe, or
some similar type of marking as shown below. (If you are not sure which
wire is positive, use a voltmeter to identify the positive wire.)
9. If you want to connect devices to the DC Out, I/O, or RS-485 pins in the
camera's terminal connector:
a. Read the information in Section 4 regarding the pin numbering and
functionality for the terminal connector and determine how you want to
connect the devices to the camera.
b. Insert the device wires into the Weidmüller plug.
8
Ground Wire
Positive Wire (marked)
GEUTEBRÜCK TopLine cameras
Werbung
