AEG FAVORIT 55033W0 Benutzerinformation Seite 37

1
3
10.2 Water drain connection
max. 850 mm
max.
4000 mm
A
2
4
min. 400 mm
3. Remove the worktop of the
appliance.
4. Loosen or tighten the adjust-
able feet for a correct level of
the appliance.
With a correct level the appli-
ance door closes and seals
correctly.
5. Install the appliance under
the kitchen counter.
Connect the water drain hose to:
• The sink spigot. Attach the water drain
hose under the kitchen counter. This
prevents that waste water from the
sink goes back to the appliance.
• A stand pipe with vent-hole. The inter-
nal diameter must be minimum 40
mm.
Remove the sink plug when the appli-
ance drains. This prevents water to go
back to the appliance.
An extension hose for the water drain
hose must be shorter than 2 m and with
the same diameter as the water drain
hose.
If you connect the water drain hose to a
trap spigot under the sink, remove the
plastic membrane (A). A not complete
removal of the membrane causes a
blockage in the spigot and problems
with drain.
The appliance has a non-return valve
that prevents dirty water to go back to
the appliance. If there is a non-return
valve in the sink spigot, remove it to pre-
vent the appliance to drain incorrectly.
ENGLISH
37