Werbung
Verfügbare Sprachen
Verfügbare Sprachen
34 www.aeg.com
•
- The appliance does not drain
the water.
•
- The anti-flood device is on.
Problem
The programme
does not start.
The appliance does
not fill with water.
The appliance does
not drain the water.
After the checks are completed, activate
the appliance. The programme contin-
ues from the point of interruption.
If the problem occurs again, contact the
Service.
9.1 The washing results and drying results are not satisfactory
Problem
The dishes are not
clean.
Possible cause
The mains plug is not con-
nected in the mains socket.
The appliance door is
open.
The fuse in the fuse box is
damaged.
The delay start is set.
The water tap is closed.
The water pressure is too
low.
The water tap is clogged or
there is limescale on it.
The filter in the water inlet
hose is clogged.
The water inlet hose has a
kink or a bend.
The anti-flood device is on.
There are water leakages in
the appliance.
The sink spigot is clogged.
The water drain hose has a
kink or a bend.
Possible cause
The filters are clogged.
The filters are not correctly
assembled and installed.
The spray arms are clog-
ged.
WARNING!
Deactivate the appliance before
you do the checks.
Possible solution
Connect the mains plug.
Close the appliance door.
Replace the fuse.
Cancel the delay start or
wait for the end of the
countdown.
Open the water tap.
Contact your local water
authority.
Clean the water tap.
Clean the filter.
Make sure that the position
of the hose is correct.
Close the water tap and
contact the Service.
Clean the sink spigot.
Make sure that the position
of the hose is correct.
If the display shows other alarm codes,
contact the Service.
Possible solution
Clean the filters.
Make sure that the filters
are correctly assembled and
installed.
Remove remaining soil with
a thin pointed object.
Werbung
