Werbung
Verfügbare Sprachen
Verfügbare Sprachen
space between the unit and the top and bottom of the control cabi-
net (for air circulation to avoid excessive heating).
Prevent the penetration of conductive or other dirt during installation
or wiring.
The unit must be connected by a qualified electrician.
Mounting of the sensors
Adhere to the mounting instructions supplied with the sensor.
Electrical connection
The national and international regulations for the installation of
electrical equipment must be adhered to.
Avoid contact with dangerous contact voltages.
Disconnect power before wiring the system! In particular con-
sider other circuits at the inputs and outputs.
To prevent malfunction due to noise voltages, the sensor cable and
load cable should be laid separately. Maximum length of the sensor
cable: 30 m.
Connection using a Combicon connector (premounted).
Combicon connectors are also available as accessories:
• Connector with cage clamps
• Connector with screw terminals
The outputs are protected against short circuits up to 100 mA. The
outputs can be programmed to be either NC or NO. In addition the
output [OUT 1] can provide an analogue signal (0/4...20 mA) of the
acceleration values.
Order no. E40171
Order no. E40173
15
Werbung
