Takeuchi TB108 Werkstatt-Handbuch Seite 301

4.3 Gear train and camshaft
4.3.1 Components
Flywheel
Flywheel hausing
Fuel injection pump
Don't disassemble!
Note) This figure shows the 3TNV76.
4.3.2 Disassembly procedure:
Disassemble in the order of the numbers in the illustration.
1)Perform steps 1) to 12) of the cylinder head disassembly procedure.
2)Remove the cooling water pump.
3)Remove the crankshaft pulley. (See Point 1 of 4.3.4)
4)Remove the gear case. (See Point 2 of 4.3.4)
5)Remove the fuel injection pump. (See Point 3 of 4.3.4)
6)Remove the idle gear assy. (See Point 4 of 4.3.4)
7)Remove the PTO drive gear. (See Point 5 of 4.3.4)
8)Remove the starting motor.
9)Remove the flywheel. (See Point 6 of 4.3.4)
10)Remove the camshaft assy. (See Point 7 of 4.3.4)
11)Remove the gear case flange. (See Point 8 of 4.3.4)
12)Remove the oil seal from the gear case. (See 4.3.6)
4.3.3 Reassembly procedure:
Reverse of the disassembly procedure.
4. Disassembly, inspection and reassembly of engines
Starter
Pump flange
Fuel pump drive gear
Flange bolt
68
Gear case
Idle gear
Camshaft
Cooling water pump
Crankshaft gear
Gear case cover
Crankshaft pulley
Camshaft driving gear
Oil seal
(R.1)