Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation procedure
1. Check the strength of the installation location.
The wall-hanging bracket weighs approximately 9 kg (19.8 lbs.) and the Plasma Display unit weighs
approximately 78 kg (172.0 lbs.) to 95 kg (209.4 lbs.).
While referring to the wall-hanging bracket installation dimensions in the diagram below, check the strength of
the wall in six installation locations, and add reinforcing if any of these locations are not strong enough.
15.4
(
/
)
39
644.6 (25
64
Units: mm (inches)
2. Install the wall-hanging bracket to the wall.
• Install the Wall-hanging bracket so that the arrow shown on the bracket is pointing upwards.
• If it is necessary to embed bolts or nuts beforehand because the wall is made from concrete, use the bracket
itself to determine the correct installation hole positions, or use the dimension diagram to calculate the hole
positions. Then embed the M6 bolts or nuts into the holes. Furthermore, when embedding the bolts, allow the
bolts to protrude from the wall by 10 mm (
Horizontal installation
Fixing screw
(M5-133)
Vertical installation
Fixing screw
(M5-133)
1320 (51
31
/
)
32
/
)
644.6 (25
/
)
3
3
8
8
Wall installation holes (6 locations)
13
/
32
Marks (V)
Marks (V)
Caution
15.4
(
/
)
39
64
• The wall-hanging bracket has
installation holes provided in 14
locations.
if the wall material will not allow
sufficient strength to be obtained from
using six installation holes, use some of
the spare holes.
However, depending on the
construction material used at the place
of installation, cracks may develop if
the screws are inserted too close to
each other.
inches) to 15 mm (
19
/
inches).
32
Installation procedure
1. First screw a bolt into the center-top
hole.
2. Use a level gauge to correct the
alignment of the wall-hanging bracket,
Marks (H)
and then screw bolts into the
remaining five holes.
3. Provisionally tighten the fixing screws.
Fixing screw
If the screws are inserted more than 5
(M5-133)
mm (
to install the Plasma Display in the
correct position.
Caution
• Use commercially-available M6 bolts
which suit the wall materials for
installation to the wall.
Note
• The marks indicate the centerline of the
Plasma Display.
13
/
inches), it will not be possible
64
9
Werbung
