Husqvarna PG 400 Bedienungsanweisung Seite 7

operation. This decreases the risk of electrical
shock.
• Keep the connection to the extension cable dry and
off the ground.
• Keep the extension cable away from heat, oil, sharp
edges or moving parts. A damaged cable increases
the risk of electrical shock.
• Make sure that the extension cable is in good
condition and not damaged.
• Do not use the extension cable while it is wound up.
This can cause the extension cable to become too
hot.
• Make sure that the extension cable is behind you
and the product when you use the product. This
prevents damage to the extension cable.
Safety devices on the product
WARNING:
instructions that follow before you use the
product.
• Do not use a product with safety devices that are
damaged or do not operate correctly.
• Do a check of the safety devices regularly. If the
safety devices are damaged or do not operate
correctly, speak to your Husqvarna service agent.
• Do not make modifications to safety devices.
ON/OFF switch
The ON/OFF switch is used to start and stop the
product.
2258 - 001 - 19.10.2023
Read the warning
To do a check of the ON/OFF switch
1. Push down the handle to lift the grinding head from
the floor. The pressure between the grinding head
and the floor decreases.
2. Set the ON/OFF switch to 1 to start the product.
3. Wait for 5 seconds to let the product operate at idle
speed.
4. Set the ON/OFF switch to 0 to stop the product.
-1 mm
7