Husqvarna PG 400 Bedienungsanweisung Seite 13

• Full set - 9 tools. Effective surface removal.
• Part set - 6 tools. Effective concentrated surface
removal.
• Part set - 3 tools. Very aggressive concentrated
surface removal
Installation of the diamond tools
The installation of the diamond tools on the tool plate
has effect on the performance of the product. The
diamond tool type together with the number of segments
on the diamond tool is important.
Use metal bond diamond tools with 2 segments for
usual grind operations, to make the surface level or light
removal.
Use metal bond diamond tools with 1 diamond segment
to increase the diamond tool pressure. This installation
is for heavy removal with much force.
For the heaviest removal, we recommend to use tools
that only run in one direction with PCD diamond tops.
2258 - 001 - 19.10.2023
Note:
™
PIRANHA tools are made to run only in one
direction.
To do before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Do daily maintenance. Refer to
on page 16 .
3. Make sure that the product is assembled correctly
and is not damaged.
4. Put the product on the work area.
5. Make sure that there are diamond tools on the tool
plate and that they are tightly attached.
6. Connect the dust extractor to the product. Refer to
To connect a dust extractor on page 15 .
7. Adjust the handlebar to set the necessary work
height.
8. Make sure that the motor cable is connected to the
electrical enclosure before the product is connected
to an electrical socket.
9. Connect the power plug of the product into the mains
outlet.
10. Make sure that you know in which direction the
motor rotates.
11. Turn the emergency stop button clockwise to make
sure that it is disengaged.
To do a check of the direction of rotation of the
motor
1. Start the product. Refer to
page 14 .
2. After some seconds, stop the product. Refer to
stop the product on page 14 .
Daily maintenance
To start the product on
To
13