Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Update via LocalNet RS 232 interface
General informa-
A software update for the following Fronius system components can be performed using
tion
the LocalNet RS 232 interface:
-
-
-
-
-
Requirements for
The following requirements must be satisfied in order to perform software updates using
using the Local-
the LocalNet RS 232 interface:
Net RS 232 inter-
-
face
-
-
-
-
-
IMPORTANT! If software with a compatible version number has already been installed,
then only the configurations need to to checked.
Install LocalNet &
1
Tools software
2
3
Configure Local-
1
Net Server Pro-
fessional soft-
2
ware
12
Power sources for the TS/TPS range (UST PC board)
Power sources for the MW/TT range (UST PC board)
Power sources for the TSt range
Clear text display on the TransTig 2500/3500 Comfort
Clear text display on the MagicWave 2500/3500 Comfort
Power source firmware TS/TPS, MW/TT OFFICIAL UST V3.29.33 or higher
Power source firmware TS/TPS, MW/TT OFFICIAL UST V4.01.06 or higher
Power source firmware OFFICIAL TransSteel V1.1.15 or higher
LocalNet & Tools software V2.6.c or higher installed on the PC
For the TS/TPS, MW/TT range, BASICLoad software V3.50.2 or higher installed on
the PC
For the TSt range, BASICLoad software V3.60.6 or higher installed on the PC
Insert the software tools CD into the CD drive or download the LNTools_X.Xx file
from the DownloadCenter (https://www.fronius.com/en/welding-technology/down-
loads).
Execute the LNTools_XX.exe file
Follow the instructions in the installation wizard
- LocalNet & Tools is installed
Execute the LocalNet Server Professional file - in the start menu under „FroniusPro-
duct Group / LocalNet SDK"
Select „COM1" from the Network drop down menu
Werbung
