Electrolux EB6GL4SP Benutzerinformation Seite 22

9. Clean the glass panel with water and
soap. Dry the glass panel carefully. Do
not clean the glass panels in the
dishwasher.
After cleaning, do the above steps in the
opposite sequence. Install the smaller panel
first, then the larger and the door.
Make sure that the glass panels are inserted
in the correct position otherwise the surface
of the door may overheat.
12.5 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the appliance and wait until it is
cold.
2. Disconnect the appliance from the mains.
3. Place the cloth on the oven floor.
Top lamp
1. Turn the glass cover to remove it.
13. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
22 ENGLISH
2. Clean the glass cover.
3. Replace the lamp with a halogen, 230 V,
40 W, 300 °C heat-resistant lamp
4. Install the glass cover.
Side lamp
1. Remove the left shelf support to get
access to the lamp.
2. Use a narrow, blunt object (e.g. a
teaspoon) to remove the glass cover.
3. Clean the glass cover.
4. Replace the lamp with a halogen, 230 V,
25 W, 300 °C heat resistant lamp.
5. Install the glass cover
6. Install the left shelf support.