Connections; Location And Assembly - Ecler eMSP50T Bedienungsanleitung

4. CONNECTIONS

In order to always obtain optimal output use the appropriate voltage and power.
100V line power selection is performed by the connection wiring according to the following
colour code:
If the horn is used in 70.7V facilities the power indicated in the table for 100V line will be
reduced to half, and to a quarter for 50V facilities.
ready to be used.

5. LOCATION AND ASSEMBLY

Unit installation should be performed with fastenings designed for the type of supporting
material. To change horn position, lightly unscrew the U-shaped bracket in order to obtain the final
position you want; keep in mind the area you want to reach to set the horn correct vertical angle.
Re-tighten the mounting screws to secure the horn in its final position.
50W
25W
12.5W
9W
4.5W
3.5W
Once the right power is selected for the application and line voltage, the horn is
RED – YELLOW
YELLOW – GREEN
GREEN – WHITE
RED - GREEN
YELLOW – WHITE
RED – WHITE
5