SOMFY TL 25 WT Setting tool Anleitung Seite 41

TL 25 WT Setting tool
2.3.2. Setting the upper end limit
1) Press the Prog. button for two secondsUpper
d d
end of
Upper end limit
Setting tool control unit
2) Press the Up
the desired upper position is reached.
Adjust the position, if necessary, using the Up
k k
and Down
3) Press the OK button until there is an up and
down movement of the drive, the OK push-
button indicator light lights up on and then
goes out, the upper position is set.
2.4. TIPS AND ADVICE ON INSTALLATION
2.4.1. Questions about the product?
Observations
The motorised
product does
not operate.
The TL 25 WT
Setting tool
does not work.
If the motorised product or the 25 WT Setting tool still does not work, contact a
drive and home automation professional.
2.4.2. Factory mode
Press the RESET button for approximately
seven seconds until there are two up and down
movements of the motorised product (the
RESET push-button indicator light lights up
for the duration of the operation), the drive is
reinitialised to its original configuration (the RESET button indicator light
LED goes out).
©
Copyright 2020 - 2022 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
The Prog. LED indicator light
e e
lights up, the TL 25 WT
b b
is active.
i i
button and release it when
buttons .
Possible causes
The TL 25 WT Setting
tool wiring is either
disconnected or not
connected.
The drive is damaged.
The TL 25 WT Setting
tool is disconnected.
1)
2 s
2)
i
Solutions
Switch off the mains power supply,
check the connections and switch
back on the mains power supply.
Contact a drive and home
automation professional.
Connect the TL 25 WT Setting
tool to a mains adaptor and plug it
into the wall socket.
7 s
EN
3)
41