Changing The Default Settings; Understanding The Menu Structure; Using The Menu; Overview Of The Main Menu - AEG DVD 4619 HC Bedienungsanleitung

English
60
Understanding
the menu structure

Using the menu

Overview of the main menu

05-DVD 4619 HC_GB.indd 60 05-DVD 4619 HC_GB.indd 60

Changing the default settings

A large number of default settings can be comfortably changed via the
screen menu.
Press the SETUP-button (Fig. 3/12) on the remote control to start the
menu for changing the default settings.
NOTE:
Many of these default settings can be changed via both the remote
control and the menu. The diff erence is: If you change the default
settings via the remote control, these changes will only be valid until
the DVD-Player is switched off or the DVD is changed.
However, any changes made in the menu are permanent.
The Setup menu has two menu levels:
Main menu: The main level is shown at the top edge of the screen by
means of generic terms.
Sub-menu: The corresponding sub-menu options can be found under
each of the main menu options.
Navigation and selection
Use the Cursor Buttons (Fig. 3/28) ( / ) on the remote control to
browse through the main menu.
In contrast to this, you must use the Cursor Buttons ( / ) to move
in the sub-menu.
Select a menu option with the ENTER button (Fig. 3/13).
Use the ENTER button also to select an option. The selected option is
now highlighted.
Slide control
In some menus you will fi nd slide controls with which you can adjust the
volume or picture brightness, for example. The slide control is used as
follows:
1. Select with the ENTER button.
2. Move the control with the Cursor Buttons ( / ).
3. Confi rm the entry with the ENTER button.
GENERAL = General Setup
VIDEO = Video Setup Page
AUDIO = Audio Setup Page
PREFERENCE = Preference Page
NOTE:
Some of the menu settings are only available in stop mode (depen-
ding on the DVD).
28.05.2009 8:08:59 Uhr 28.05.2009 8:08:59 Uhr