Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
General safety instructions
To avoid the risk of fi re or an electric shock, you should
not expose the device to rain or moisture. Consequently,
do not use the device in the immediate vicinity of water
- for example near a bath tub, a swimming pool or in a
damp cellar.
Use the device only for the intended purpose.
Only connect the device at a properly installed plug
socket. Pay attention that the specifi ed voltage corres-
ponds to the voltage of the plug socket.
When using external mains supply, pay attention to the
correct polarity and voltage. Always place the batteries
in the correct direction.
Assemble the device in such a way that the available
ventilation openings are not covered.
Never open the housing of the device. Incorrect repairs
can constitute a considerable risk for the user. Should
the device become damaged, in particular the mains
supply cable, do not operate the device any longer, but
rather have it repaired by an expert. Check the mains
supply cable regularly for damage.
For safety reasons a broken or damaged mains lead may
only be replaced by an equivalent lead from the manuf-
acturer, our customer service department or a similary
qualifi ed person.
If the device is not used for a longer period, remove the
plug connector from the plug socket or take out the
batteries.
These symbols may be found on the machine and are
intended to indicate the following:
The lightning symbol should advise the user
of parts in the inside of the device which carry
dangerously high voltage levels.
The symbol with an exclamation mark should
advise the user of important operation or
maintenance instructions in the accompa-
nying documentation.
Devices bearing this symbol work with a
„class 1 laser" for tracing the CD. The built-in
safety switches should prevent the user being
exposed to dangerous laser light, which is
invisible to the human eye, when the CD compartment
is opened.
Under no circumstances should these safety switches
be bypassed or manipulated, as this could result in a
danger of exposure to the laser light.
5....-05-SRR 4300 CD AEG 25
Description of the Controls
1 Handle
2 Mains connection
3 PHONES headphone connection
4 VOLUME -/+
5 BBS button (ON/OFF)
6 I
CD button (skip backwards)
7 Function selector
(CD / TAPE / POWER OFF / RADIO)
8
I CD button (skip forwards)
9 PROG button (CD programming)
10 POWER control lamp
11 PROGRAM control lamp
12 LED display
13 REPEAT control lamp
14 PLAY/PAUSE control lamp
15 CD REPEAT button
16
/II CD play/pause button
17 Band selector switch (AM/FM/FM ST)
18
CD Stop button
19 Station scale
20 PUSH/OPEN button – CD compartment
21 FM/ST control lamp
22 TUNING control
23 FM / UKW Aerial
24 CD compartment
25 PAUSE button
26 STOP/EJECT Stop/Eject key
27 F.FWD Fast Forward key
28 REW Fast Rewind key
29 PLAY Playback key
30 RECORD Recording key
31 Cassette compartment
32 Battery compartment
33 Loudspeaker
Start-up of the device/introduction
•
Read the operating instructions thoroughly before the
start-up!
•
Select an appropriate location for the device, e.g. a
dry, fl at, non-slip surface on which the device can be
easily operated.
•
Make sure that the device is adequately ventilated!
Power supply
Connect the supplied cable to a duly installed 230 V/50
Hz protective contact socket and to the cable socket on
the back of the device. Make sure that the line voltage
meets the specifi cations on the nameplate. The POWER
(10) control lamp shows that the device is switched on.
Inserting the Batteries (not supplied)
•
Open the lid of the battery compartment (32) on the
bottom.
•
Insert 8 batteries of type LR 14, C, 1,5V (not sup-
plied). Please ensure that the polarity is correct (see
the fl oor of the battery compartment or the inscrip-
tion on the outside)! If the device is not used for a
long period of time, remove the batteries to avoid the
spilling of battery acid.
•
When the mains cable is connected the batteries are
switched off automatically.
25
05.02.2004, 9:30:11 Uhr
Werbung
Inhaltsverzeichnis
