Connecting The Video Cable - AEG DVD 4619 HC Bedienungsanleitung

Connecting a Ribbon Cable
Fig. 2/18
Connect the earth
Fig. 2/26

Connecting the Video cable

Fig. 2/19
05-DVD 4619 HC_GB.indd 47 05-DVD 4619 HC_GB.indd 47
NOTE:
The signals from the remote control are transmitted to the DVD-Player
by infrared light. You should therefore take care that the DVD-Player is
not exposed to the direct sunlight. This could make the transmission of
signals from the remote control to the DVD-Player impossible.
Eff ective range of the remote control
If you want to use the remote control it has to be pointed at the remote
control sensor on the front of the device. The distance between remote
control and sensor should not exceed 7m. The angle of the remote control
to the remote control sensor to right, left, top and bottom should not
exceed 30°.
Connect the two device components with the ribbon cable.
Insert the ends of the ribbon cable into the corresponding sockets on
the back of the devices.
Link the earth connections of the two device components with the earth
cable.
Undo the screw terminals on the back of the device.
Guide the earth plugs around the screw threads and then retighten
the screw terminals.
The video cable transmits the video data from your DVD-Player to the TV
or the Video-Projector.
There are fi ve diff erent ways of connecting the DVD-Player with your TV/
Video-Projector. Select one of these possibilities to suit your replay unit.
NOTE:
If you are not using a SCART or HDMI connection you must always
establish an additional audio connection for transmitting the audio
data (i.e. the sound).
SCART
SCART is used to transmit both Video and Audio data.
1. Plug the SCART jack fi rmly into the socket on the back of the player.
2. Plug the SCART jack into the corresponding socket on your playback
device.
English
47
28.05.2009 8:08:56 Uhr 28.05.2009 8:08:56 Uhr