Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4. MOUNTING AND CONNECTION
1
Fix the LED ribbon at a desired place by means of the self-adhesive foil on the rear side.
2
Connect the plug of the control unit via the link connector to the input
connector at one end of the LED ribbon. The arrows of both plugs must
point to each other. Otherwise the LEDs do not light up.
3
Fix the control unit at a suitable place with two screws. Alternatively use double-sided adhesive tape.
4
Fix the infrared sensor with adhesive tape so that it is capable of receiving the control signals from the
remote control without obstacles.
5
Connect the supplied power supply unit to power input at the control unit and to a mains outlet. The
LEDs light up according to the last control program selected.
6
The LED ribbon can be cut at the
Assign this task to a skilled professional. For custom-made versions, please be aware that the power
supply unit can only be loaded with 48 W maximum. Thus the maximum length of LED ribbon that can
be connected to one control unit is limited to 11 meters. Only then all LEDs show the same brightness
and the current-carrying cables of the LED ribbon set are not overloaded.
Interconnecting several LED ribbons
1
Connect the control unit to the input connector at one end of the LED ribbon in the chain as described
above.
2
Then connect the other end to the connector of the subsequent LED ribbon.
3
Connect further LED ribbons in the same way. All lengths available can be combined as desired.
4
Always make sure that the arrows on the connectors point to each other.
5
The maximum number of LED ribbons that can be interconnected to one control unit varies with each
model. Please consult chapter Technical Specifications at the end of this user manual.
5. OPERATION
Remote control
1
The remote control is supplied with battery inserted.
2
An insulating foil between the battery and the battery contacts prevents the battery from being
discharged during storage. Prior to the first operation remove the foil from the battery support on the
rear side of the remote control. Otherwise operation of the remote control is not possible.
3
When actuating a button, always hold the remote control in the direction of the ensor. There must be
visual connection between the remote control and the sensor.
4
If the range of the remote control decreases (3 meters as a maximum),
replace the battery. For this purpose, on the rear side of the remote control
press the small bar with the groove to the right and at the same time remove
the battery support.
5
For operation, one 3 V button cell type CR 2025 is required. When inserting, pay attention that the
positive pole of the button cell shows upwards in the support.
Danger of explosion when battery is replaced improperly. Only replace by the same type. Please dispose of
old and used batteries properly. Batteries are hazardous waste and should not be disposed of with regular
marks. As a result the connection wires must be soldered anew.
CAUTION!
domestic waste!
11/13
00062139.DOC Version 1.2
Werbung
Inhaltsverzeichnis
