Mounting And Connections; Cleaning And Maintenance - EuroLite LED IP PIXEL STRIP 160 5m RGB 12V Bedienungsanleitung

4

MOUNTING AND CONNECTIONS

1
The LED strip can be cut with scissors at
the cutting marks every 12.5 cm between
sets of soldering points. LED strips can
be connected by soldering or using
solderless clamps (commercially
available).
2
Place the LED strip at a desired place. There should is sufficient air
circulation to ensure a long lifespan of the LEDs.
3
Connect the plug of the LED strip to the control unit. The colors of the
wires must match.
4
Connect the LED strip to a 12 V power unit (accessory).
5
It is possible to interconnect serval LED strips. Always connect the end
of an LED strip to the input connector of the subsequent strip. Each LED
strip requires a separate power unit.
...............................................................................................................................................
5

CLEANING AND MAINTENANCE

Disconnect from mains before starting maintenance operation!
We recommend a frequent cleaning of the device. Please use a moist, lint-
free cloth. Never use alcohol or solvents!
There are no serviceable parts inside the device. If defective, please dispose
of the unusable LED strip in accordance with the current legal regulations.
Should you have further questions, please contact your dealer.
www.eurolite.de
DANGER TO LIFE!
10