STIEBEL ELTRON CON 10 S Bedienung Und Installation Seite 11

OpeRATION
Appliance description
2.3 general information
Material losses
!
Never cover this appliance.
Never stand on the appliance.
2.4 ce designation
The CE designation shows that the appliance meets all essential
requirements according to the:
- Electromagnetic Compatibility Directive
- Low Voltage Directive
2.5 test symbols
See type plate on the appliance.
3. appliance description
The appliance is a wall mounted electric direct heater. The ap-
pliance heats up the indoor air and maintains the selected tem-
perature.
The external casing of the appliance is made from stove enamelled
sheet steel. The sides are made from plastic. The controls are
located on the r.h. side panel.
The appliance is delivered complete with connecting cable and
standard plug.
4. operation
1 Temperature selector
starting heating
f Turn the temperature selector clockwise to the required f
temperature.
The appliance switches off as soon as the selected room temper-
ature has been reached.
stopping heating
f Turn the temperature selector fully anti-clockwise. f
www.stiebel-eltron.com
shutting down
f Pull the plug from the power socket. f
Frost protection
f Turn the temperature selector to the frost symbol. f
The thermostat starts the heating system automatically if the room
temperature drops below the frost protection temperature.
5. cleaning, care and maintenance
The appliance contains no user serviceable parts.
f Clean the appliance when cold with ordinary cleaning f
products.
f Avoid abrasive or corrosive cleaning products. f
f If a pale brownish discolouration appears on the appliance f
casing, wipe this off as soon as possible with a damp cloth.
Material losses
!
Never spray cleaning spray into the air slot.
6. storage
f When not in use, keep the appliance in a dry place. f
7. troubleshooting
If the appliance does not heat, check the temperature set at the
appliance and the MCB/fuse in your fuse box.
The appliance has a safety temperature controller that shuts the
appliance down if it overheats. After the cause has been removed
(e.g. covered air outlet or inlet apertures) and the appliance has
1
cooled down for a few minutes, the appliance starts again.
If you cannot remedy the fault, notify your qualified contractor.
To facilitate and speed up your enquiry, please provide the serial
number from the type plate (000000-0000-000000).
CON 10-30 S 11