Klarstein WONDERWALL Bedienungsanleitung Seite 20

EN
20
OPERATION
1
Plug the power plug into the mains socket.
2 Turn on the main switch. You will hear a beep. The large display will light
up, [--] will be displayed, the WiFi icon will flash and the heater will go into
standby mode.
3 Press the ON/OFF button on the display. The preset temperature of 25 °C
will be displayed. The device starts heating when the room temperature is
below 25 °C. In this case, the heating symbol will light up. The device stops
heating as soon as the room temperature reaches or exceeds 25°C.
4 Press the or
button increases or decreases the temperature by 1 °C. The temperature
can be adjusted from 5-50 °C. The set temperature flashes on the display
for 5 seconds and is then accepted.
5 The device starts heating when the set temperature is higher than the
room temperature. The unit stops heating when the room temperature
reaches or exceeds the set temperature.
6
Press the button until the symbol
can now set the timer with the
increases or decreases the time by 1 hour. The time can be set from
0-24 hours. The set time flashes on the display for 5 seconds and is then
accepted.
7
Press and hold the button
and slow flashing.
buttons to set the temperature. Each press of the
for timer mode lights up. You
or button. Each press of the button
to disconnect WiFi or toggle between fast