Atlas Copco ETV STB63-100-13-IRC-W Produktanweisungen Seite 7

ETV STB63-100-13-IRC-W
Maintenance
Lubrication
Planetary gears, needle bearings and ball bearings must be lubricated with soft
grease containing molybdenumdisulphide at the regular overhaul of the tool.
Take care to use specified quantity. Too little as well as too much will cause
problems.
Lubricating guide
Brand
Molycote
CRC
Brand
Molycote
Almagard
Overhaul
Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is main-
tained.
Service must only be carried out by qualified personnel who have access to the
Service instruction and/or have been trained for service on Tensor STB Tools.
The electric motor is a sealed unit and may under no circumstances be opened
by anyone else than Atlas Copco Industrial Technique AB!
If it is judged that the electric motor is defect or in need of service, the complete
motor unit should be returned to Atlas Copco Tools for exchange.
Motors which have been opened by anyone else than Atlas Copco Tools will
not be serviced.
Overhaul and preventive maintenance is recommended at regular intervals once
per year or after maximum 250.000 tightening depending on which occurs
sooner. More frequent overhaul may be needed if the machine is used in heavy-
duty operations. If the machine not is working properly, it should immediately
be taken away for inspection.
When dismantling the tool always use the specially designed service tool 4080
0848 80, (two service tools are required).
EN
Cable nut
Litium grease No. 3020
Angle gears
Longterm 2 plus
© Atlas Copco Industrial Technique AB - 9836 894900 00
Safety and operating instructions
Gears
BR2 Plus
General purpose
LE 3751
7